One Cooling-System Cart, Three Jobs: Pressure Test, Vacuum Hold, Refill

Separate three related jobs—cold pressure testing, vacuum holding and vacuum refill—before choosing one kit or cart.

Separate three related jobs—cold pressure testing, vacuum holding and vacuum refill—before choosing one kit or cart.

The AUTOOL SC301 is a 2-in-1 automotive cooling system tester and coolant vacuum filler for cooling system vacuuming, coolant filling, and pressure leak detection. It uses vacuum extraction and pressure-holding detection to help users check cooling system sealing, remove air…

A BMW 528 with a B48 engine and 130,000 km repeatedly requested coolant but left no obvious puddle. Pressure loss and dried coolant traces led beneath the intake area to two confirmed leak points: the oil-filter-housing interface and a cracked cylinder-block coolant-pipe connector. Both were repaired before vacuum filling, bleeding, a 20 km road test, and a dry recheck; the page/video model-year conflict is disclosed rather than resolved by guesswork.

Pink residue on a 2020 GLE 350 led to a leaking molded side pipe near the turbocharger. The applicable stainless-steel replacement passed the reported 15-minute sealing check.

A W205 C180 had repeated coolant warnings, a parking stain and coolant odor. Fresh leakage at the thermostat-housing seam confirmed the fault before assembly replacement and verification.

A 220,000 km BMW 525Li had intermittent overheating. Diagnosis found a coolant-damaged water-pump connector and a second heater-valve leak; both repairs passed a 20 km road test.

A 140,000 km GLC 300 had cold-start rustling, a cracked belt, weak tensioner action and rough pulleys. The drive was repaired; thermostat work was recorded separately as preventive maintenance.

A 2019 E300 with 120,000 km displayed a red stop-engine coolant warning. Pink residue led to a cracked bypass pipe; replacement, bleeding and a 30 km road test completed the repair.

Coolant near a water pump does not prove pump failure. Use a cold inspection, bounded vacuum-hold test, repair boundary, vacuum fill and verification.